Giving Thanks to Snapmaker Amazing StarMakers!
Hello Snapmaker Community,
Top StarMakers
Snapmaker Original/2.0 Owners


Snapmaker J1/J1s Owners

Snapmaker Ray Owners

Here comes the second showcase from our StarMaker. Take a look at this fantastic ceramics art piece!
I’m Aki, an engineer from Japan. I have been doing aquariums for over 10 years and It’s my strong point. When I knew that the contest was about plants, I immediately decided to use aquatic plants as my key idea. I then came up with several ideas to represent spring with aquatic plants.
The satisfaction is huge – the neon is eye-catching and it looks just like I imagined.
Printed by: Keelan Runnalls (Instagram @brokenbarrelhomestead) Scale: 1/20 3D printer: Snapmaker A350 in the Enclosure Dimensions: Fin tip to fin tip: 290mm (11.5in or 1.5 bananas), Trunk Diameter (without fins): 195mm (7.5in or 1 banana), Height (top of Nose Cone to bottom of the Trunk): 405mm (16in or 2 bananas) Supplies: Print time: Approximately 300…
My eyes fell upon an invitation card left by my friend for their wedding. That’s when it occurred to me why not make customized wedding stamps?
Check out the amazing republic commando helmet from our community!